A Mission garage door shop that knows the houses here

Who You Are Dealing With

Mission Garage Door Co is based at 4101 S Shary Rd, Mission, TX 78572, and we work on the doors that are actually in the ground here. Most of the houses we get called to went up between 1987 and 2005, with a median build year around 1997 - that's the bulk of the stock across the 26 named areas we cover, from Palmview South and Palmhurst out to La Blanca. That build window matters. It's when steel sectional doors with extension or standard torsion springs became the default, replacing the older one-piece doors you still find scattered in older pockets. We're not guessing at what's behind your wall when we quote a spring size or an opener bracket, because we've seen the same production-era hardware house after house.

We size jobs for this area, not for a national average. A household here making the area's median income of $48,777 a year isn't looking to replace a whole door system on a whim, and we don't push that as a first option when a spring, cable, or roller swap solves the problem. We'd rather fix the door you have than sell you one you don't need yet.

How to Reach Us

Call (956) 552-8925. That's the number that reaches us directly - no call center routing you somewhere else. We're at 4101 S Shary Rd, Mission, TX 78572, which puts us within a short run of Palmview South (3 mi), Palmview (4 mi), Palmhurst (4 mi), and West Sharyland (5 mi), and still a reasonable drive out to Abram, La Homa, Alton, and Doffing in the 5-6 mile range.

We also take calls from farther out - Penitas, Hidalgo, Pharr, Citrus City, La Joya, San Juan, and the rest of the areas listed on our service map, out to La Blanca at 20 miles. If you're not sure whether you're in range, just call and ask; it's faster than guessing from a map.

Work We Turn Down

We don't replace a door that only needs a spring, a cable, or a set of rollers just because replacement pays better. If the frame is square, the track isn't bent, and the panels aren't rusted through, we tell you that and fix the part that failed.

We also don't take on structural carpentry - if your opening needs a new header or jamb because of rot or a remodel, that's a job for a general contractor first, and we come in after the frame is sound. And we won't quote a same-day install on a non-stock size door; special-order panels run on the manufacturer's lead time, not ours, and we tell customers that up front instead of promising a date we can't hit.

Given the heat load this area carries, we also won't tell you a cheap foam-core door will outperform a properly insulated one on a west-facing opening - if your garage bakes all afternoon, we'll say so instead of selling the cheaper unit and letting you find out in August.

What We Actually Do

Spring replacement - torsion and extension - sized to the door weight and opening, not a generic one-size spring. Cable and roller swaps. Track realignment when a door's walked off its rails. Opener repair and replacement, including circuit boards, sensors, and drive gear wear. Panel replacement when a section's been hit but the rest of the door is sound.

Given the severe heat this area sits in, we pay attention to how hardware ages here - nylon rollers and opener gears break down faster under sustained high temperatures than they do in a milder climate, so we check those parts even on calls that start as something else. We service the areas listed above, centered on the housing stock built in the 1987-2005 window that makes up most of what's out there. If your door or opener predates that - an older one-piece door on original hardware - we still work on it, but parts can take longer to source, and we'll tell you that before we start, not after.

Frequently asked questions